06-01-2007 08:59 AM - edited 03-05-2019 04:26 PM
Hello all,
i'm trying to get the dot1p tagged frames on my wireshark , these frames are going out of my 440x controller that is connected through a trunk to my 3750 switch. When I enter the following CLIs:
SW-3750-2(config)#monitor session 1 source interface gigabitEthernet 1/0/25
SW-3750-2(config)#monitor session 1 destination interface gi 1/0/1 SW-3750-2(config)#$sion 1 destination interface gigabitEthernet 1/0/1 ?
, Specify another range of interfaces
- Specify a range of interfaces
encapsulation Set encapsulation for destination interface
ingress Enable ingress traffic forwarding
<cr>
my monitoring station receive frames untagged in the wireshark. Do I need to change the registry of my LAN adapter to see the dot1p coppied frames?
Thanks in advance for your help!
Best ,
Michal
06-08-2007 07:01 AM
Replace the 'switchport voice vlan dot1p' command with the 'switchport voice vlan x'command where 'x' is the vlan designated for voice traffic.
06-08-2007 11:33 AM
Friend,
This link might help
http://wiki.ethereal.com/CaptureSetup/VLAN#head-2b2ad01a440f272e00406dd1fe6d6a1477040bdc
HTH, rate if it does
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: