POST: ILP Controller Tests

Unanswered Question
Jun 1st, 2007
User Badges:

posted below is the output from the post. I then receive an output stating.

!!! WARNING: The switch is not usable !!!



I searched on google and on ciscos site for information even on ILP Controller and nothing comes back.... any suggestions?


The system light is orange.


POST: ILP Controller Tests : End, Status Failed

INIT: failed ILP accessing test

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
rbreidenstein Mon, 06/04/2007 - 05:41
User Badges:

could it mean In Line Power? but why would that cause the whole switch to fail?

Amit Singh Mon, 06/04/2007 - 06:59
User Badges:
  • Cisco Employee,

Rick,


That's a Power on Self-Test POST failure. Its related to inline power controller hardware failure. Please go ahead and raise an RMA request, its a hardware failure on the box.


HTH,Please rate if it does.


-amit singh

karunanithi Fri, 01/11/2008 - 04:42
User Badges:

Hi,


Thanks for your help, it really helps, I am facing same issue with my switch.


regards

karuna

Actions

This Discussion