cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1831
Views
4
Helpful
3
Replies

POST: ILP Controller Tests

rbreidenstein
Level 1
Level 1

posted below is the output from the post. I then receive an output stating.

!!! WARNING: The switch is not usable !!!

I searched on google and on ciscos site for information even on ILP Controller and nothing comes back.... any suggestions?

The system light is orange.

POST: ILP Controller Tests : End, Status Failed

INIT: failed ILP accessing test

3 Replies 3

rbreidenstein
Level 1
Level 1

could it mean In Line Power? but why would that cause the whole switch to fail?

Rick,

That's a Power on Self-Test POST failure. Its related to inline power controller hardware failure. Please go ahead and raise an RMA request, its a hardware failure on the box.

HTH,Please rate if it does.

-amit singh

Hi,

Thanks for your help, it really helps, I am facing same issue with my switch.

regards

karuna

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco