Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1859
Views
4
Helpful
3
Replies

POST: ILP Controller Tests

rbreidenstein
Level 1
Level 1

‎06-01-2007 11:03 AM - edited ‎03-05-2019 04:26 PM

posted below is the output from the post. I then receive an output stating.

!!! WARNING: The switch is not usable !!!

I searched on google and on ciscos site for information even on ILP Controller and nothing comes back.... any suggestions?

The system light is orange.

POST: ILP Controller Tests : End, Status Failed

INIT: failed ILP accessing test

Labels:
0 Helpful
3 Replies 3

rbreidenstein
Level 1
Level 1

‎06-04-2007 05:41 AM

could it mean In Line Power? but why would that cause the whole switch to fail?

0 Helpful

Amit Singh
Cisco Employee
Cisco Employee
In response to rbreidenstein

‎06-04-2007 06:59 AM

Rick,

That's a Power on Self-Test POST failure. Its related to inline power controller hardware failure. Please go ahead and raise an RMA request, its a hardware failure on the box.

HTH,Please rate if it does.

-amit singh

karunanithi
Level 1
Level 1
In response to Amit Singh

‎01-11-2008 04:42 AM

Hi,

Thanks for your help, it really helps, I am facing same issue with my switch.

regards

karuna

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card