cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
278
Views
5
Helpful
1
Replies

Routing issue when using Remote access

mahzoddc06
Level 1
Level 1

Hi All,

I have the following setup:

layer 3 Switch --192.168.1.x/24-- ASA5520 --192.168.7.x/24-- Internet Router ----- VSAT

I have configured the Internet Router to do PATing for the DATA VLAN on the L3 Switch. I have also configure the Internet Router to redirect any request for UDP 500 to the Outside Interface of ASA5520

I am able to establish a VPN tunnel which successfully terminates on the Outside interface of the ASA5520, however i am having a problem pinging the internal vlans (such as the DATA VLAN).

I have set the ASA5520 with the "tunneled default route".

Any ideas to trouble this problem??

1 Reply 1

mahzoddc06
Level 1
Level 1

I didn't include the IPsec NAT-Traversal on the ASA5520...its working fine now

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card