06-03-2007 11:43 PM
All,
I have configured an ACE with some contexts. I think I have configured it according to the documentation.
If I switch to a different context using the changeto command, I switch to the context, but get the following error message:
NOTE: Configuration mode has been disabled on all sessions.
Anyone has an idea how to solve this?
Thanks, Pieter-Jon Buitelaar
06-04-2007 04:18 AM
Pieter,
you can only change the config on the active ACE. So, verify if you are on the active unit with the 'sho ft group det' command.
Gilles.
06-04-2007 04:54 AM
Gilles,
I am running a single ACE in single mode not in FT mode.
However, after rebooting the ACE module, I was able to go into conf mode in all contexts.
Any explanation for this behavior?
Thanks for your reply, Pieter-Jon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: