06-04-2007 03:55 AM - edited 03-03-2019 05:17 PM
hai
i want to puthrough a circuit with tellabs ethernet modems one end and other end with cisco 7204 channelized e1/pri slot with bridge mode configuration
what commands shall i give on e1/pri slot ?
can any body guide me
7204 router ios ver is 12.1
with regards
manjula
06-04-2007 12:50 PM
Hi,
Are you trying to bridge IP ? If, so what is the reason? As you should not do that normally.
06-05-2007 01:56 AM
hi
i have to connect one pc through wan link to central location
i dont want to use router at remote end for single pc
i can build through lan extenders by connecting to switch at central location and remote end directly to pc
but i want to extend this wan link to channelized e1/pri at central location and bridge modem at remote end
manjula
06-06-2007 12:04 AM
Hi,
Before worrying about bridging you should try to have this lan extender to communicate with the router via its serial interface and PPP.
After that the configuration is generally limitited to "bridge irb" and configuring a BVI interface.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide