I am setting up 2 PIX 506E's as firewalls. I am not Cisco trained or certified and I'm trying to figure some of this stuff out as I go. Not the ideal situation, but we're a nonprofit without tons of cash for training so there it is.
Anyway, I do have over 20 years in IT so I'm not completely lost, but I am stuck on this particular problem. My 506E will not let me ping the outside interface from the inside interface. It does let me ping the inside interface from a computer on the inside network. I am hoping someone can give me a command to allow pinging the outside interface from the inside network.
I would paste my config here but I'm not sure which parts are relevant and I don't want to go over the character limit.
no access-group inbound in interface inside
You acl is wrong, you do not refer to the destination by the private ip address.
access-list inbound permit tcp any host 192.168.2.1 eq www
access-list inbound permit tcp any host 126.96.36.199 eq www