mohammedmahmoud Mon, 06/04/2007 - 22:52
User Badges:
  • Green, 3000 points or more

Hi,


You should most probably have a one-to-one relation between VRFs and VLANs according to your design.


As for configuring BGP per VRF, you need to use address-families, something like this:


ip vrf test

rd


interface x

ip vrf forwarding test

ip address x.x.x.x



router bgp

address-family ipv4 vrf test

neighbor remote-as

network mask




HTH, please do rate all helpful replies,

Mohammed Mahmoud.

ariela Mon, 06/04/2007 - 23:42
User Badges:
  • Silver, 250 points or more

just a little specification:


interface x = interface vlan x ;)


interface vlan x

ip vrf forwarding

ip address x.x.x.x


Regards

Andrea

mohammedmahmoud Mon, 06/04/2007 - 23:46
User Badges:
  • Green, 3000 points or more

Hi Andrea,


You are most probably right :)


But i didn't know the original poster's topology (i mean how does he do the inter-VLAN routing), he might be doing router-on-a-stick, and thus i gave it to him in a generic manner and he should work it out.



BR,

Mohammed Mahmoud.

ariela Tue, 06/05/2007 - 00:18
User Badges:
  • Silver, 250 points or more

Yes, Mohammed,

you are right :)

The original post is generic ...


Regards

Andrea

Actions

This Discussion