adding incoming numbers

Unanswered Question
Jun 4th, 2007
User Badges:

Hi All,


We have a Cisco 2801 Router with a 15 Channel ISDN and an internal IP Telephone System. Our Phone Service Provider has already given us a 100 range of numbers attached to the 15 Channels, but is going to add 2 additional individual numbers completely outside of this range.


I need to know that our router will accept calls for these numbers and pass them to our IP telephone server to determine which extension is to receive the call.


Currently I see two areas that refer to our 100 range as it is now. Would I need to add these 2 individual numbers in these areas as well?


translation-rule 22

Rule 1 02811780 811780


and the following I believe is only for outgoing calls which does not matter, I do not need calls to me made outgoing via these 2 additional numbers.


dial-peer voice 3 voip

translation-profile outgoing calling

destination-pattern 811780..

voice-class codec 1

max-redirects 10

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

no vad


If I have not made any sense, please ask me any questions you may have.


Thankyou in advance for your help.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
drolemc Fri, 06/08/2007 - 12:18
User Badges:
  • Silver, 250 points or more

Called number (DNIS) with incoming called-number


First, the router or gateway attempts to match the called number of the call set-up request with the configured incoming called-number of each dial-peer. Since call setups always include DNIS information, it is recommended to use the incoming called-number command for inbound dial peer matching. This attribute has matching priority over answer-address and destination-pattern.


http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

pjscott13 Wed, 07/11/2007 - 23:11
User Badges:

Yeah we already had that set up. I just did not include it in my post.


dial-peer voice 1 pots

voice cut-through alert

description Incoming ISDN Dialpeer

incoming called-number .

direct-inward-dial

port 0/1/0:15

!

dial-peer voice 2 pots

description Outbound DialPeer

destination-pattern 0T

port 0/1/0:15

!

dial-peer voice 3 voip

translation-profile outgoing calling

destination-pattern 866780..

voice-class codec 1

max-redirects 10

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

no vad

!

dial-peer voice 4 voip

translation-profile outgoing calling

destination-pattern A800AT

voice-class codec 1

max-redirects 10

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

no vad

!

dial-peer voice 5 voip

translation-profile outgoing calling

destination-pattern .

voice-class codec 1

max-redirects 10

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

no vad

!


I'm still not sure what to do here though. I think I might have a translation issue.

Actions

This Discussion