Cisco 7920 Wireless IP Phone - Firmware 7920-4.0-03-01: EAP-FAST

Unanswered Question
Jun 4th, 2007

I am planning to migrate wireless IP Phone firmware from 4.0-02-01 to 4.0-03-01, I read the document this new firmware can support EAP-FAST authentication.

I am facing a problem its not getting the PAC from the RADIUS but my laptop clients are able to access the PAC without any problem.

I found the problem only in Cisco Wireless 7920 IP Phones, please help anyone face this issue.

Thanking you,

Ranga Kishore

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
migilles Tue, 06/05/2007 - 00:10

If using the Cisco Unified controller, then need to increase the 802.1x timeout on the controller, which is mentioned in the release notes @ http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7920/relnotes/rn302.htm#wp169464.

Sounds like you have automatic PAC provisioning enabled already, which is required.

Also would recommend 3.02, which was just released recently.

Actions

This Discussion