×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Caller ID ICT

Unanswered Question
Jun 5th, 2007
User Badges:

Hi all,


I had a issue with the Caller ID display on the IP phones when I configure a Non-Gatekeeper ICT connection between two Callmanager Cluster.


It seems like when I try to call a phone from Cluster "A" to Cluster "B". I got the 4 digit DN from Cluster "B" phone displayed on Cluster "A" phone.


I understand that the caller display is send from Cluster "B" to A. But I will like the orignating dialed number to appear.


Can anyone help.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
espereir Tue, 06/05/2007 - 18:03
User Badges:
  • Silver, 250 points or more

Hello Jeremy,


I believe that you mean that after the call is connected, you get 4 digits, this is normally a configuration on the route pattern where you need to enter the CLID transformation masks on both clusters.

Actions

This Discussion