Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
267
Views
0
Helpful
1
Replies

2960 and Routing on Linux

Peterson Cristovam
Level 4
Level 4

‎06-05-2007 05:10 AM - edited ‎03-05-2019 04:29 PM

HI.

I created vlans (115,116) in my catalyst 2960 and in my linux server i created subinterfaces. The encapsulation is dot1q. The port to linux server has configured like trunk mode, but there aren't communications between vlans. Can you help me? In PC's, the default gateways is the subinterface of linux. Perhaps it has a problem in vlan 1?

Thanks

Labels:
0 Helpful
1 Reply 1

Harold Ritter
Cisco Employee
Cisco Employee

‎06-05-2007 05:29 AM

Did you enable IP forwarding on the Linux station. It is disabled by default on most Linux stations. Please refer to the following document to see how to enable IP forwarding:

http://www.ducea.com/2006/08/01/how-to-enable-ip-forwarding-in-linux/

Hope this helps,

Harold Ritter
Sr Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card