06-05-2007 06:49 AM - edited 07-03-2021 02:10 PM
Has anybody seen this error message. "dtlArpRequest: Cannot send an ARP reply to 00:0B:85:86:4D:20" It happens when I change the WLC to lag. It works fine without lag turned on. There is about 17 aps on it. As soon as I turn it on and reboot the WLC about 10 of the aps come up. Over time the aps get fewer and fewer until there is 0 aps. Any ideas?? I have checked the switch config per cisco specs and I still have same problem. I have upgraded to 4.0.206 to 4.1.
06-05-2007 07:33 AM
Hi Friend,
I believe you might have reloaded the controller once after you enabled LAG? Also what is the channel-group mode set to on switch side?
Also can you paste the output of "sh interface sum" from controller?
Regards,
Ankur
06-05-2007 07:40 AM
I reloaded it multiple times. Channel-group mode is on. I actually can not because lag is turned off now. I can only do it when I take it down. Thanks for the response.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: