06-05-2007 06:49 AM - edited 07-03-2021 02:10 PM
Has anybody seen this error message. "dtlArpRequest: Cannot send an ARP reply to 00:0B:85:86:4D:20" It happens when I change the WLC to lag. It works fine without lag turned on. There is about 17 aps on it. As soon as I turn it on and reboot the WLC about 10 of the aps come up. Over time the aps get fewer and fewer until there is 0 aps. Any ideas?? I have checked the switch config per cisco specs and I still have same problem. I have upgraded to 4.0.206 to 4.1.
06-05-2007 07:33 AM
Hi Friend,
I believe you might have reloaded the controller once after you enabled LAG? Also what is the channel-group mode set to on switch side?
Also can you paste the output of "sh interface sum" from controller?
Regards,
Ankur
06-05-2007 07:40 AM
I reloaded it multiple times. Channel-group mode is on. I actually can not because lag is turned off now. I can only do it when I take it down. Thanks for the response.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide