cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
655
Views
0
Helpful
4
Replies

PVDM2-12DM

giaaaj
Level 1
Level 1

I have a problem with PVDM2-12DM. I have installed a PVDM2-12DM in a Cisco 2811 with a E1 Controller.

The Output of show diag. is the following.

PVDM Slot 0:

No Card PVDM daughter card

Hardware Revision : 1.0

Part Number : 73-10100-03

Board Revision : B0

Deviation Number : 84758

Fab Version : 03

PCB Serial Number : FOC10223PUR

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Processor type : 00

Product (FRU) Number : PVDM2-12DM

Version Identifier : V01

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 04 8E 41 01 00 82 49 27 74 03 42 42 30

0x10: 88 00 01 4B 16 02 03 C1 8B 46 4F 43 31 30 32 32

0x20: 33 50 55 52 03 00 81 00 00 00 00 04 00 09 00 CB

0x30: 8A 50 56 44 4D 32 2D 31 32 44 4D 89 56 30 31 20

0x40: D9 02 40 C1 FF FF FF FF FF FF FF FF FF FF FF FF

0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

-------------------

- What the meaning of "No Card PVDM daughter card"?

- The LED on the router for PVDM0 and PVDM1 is not active . Whay ?.

can somebody help.

4 Replies 4

paolo bevilacqua
Hall of Fame
Hall of Fame

Hello,

the "No Card" part of the output appears to be a cosmetic bug, does the pvdm2 actually work ?

No it does not work.

The LED on the Router is inactive and i am not able to configure it in a line command

ACCG007(config)#line ?

<0-326> First Line number

aux Auxiliary line

console Primary terminal line

tty Terminal controller

vty Virtual terminal

x/y Slot/Port for Modems

x/y/z Slot/Subslot/Port for Modems

actualy for a PVDM2-12DM i should be able to configure the line from 322 to 333 ( 12 lines) but i see only the outbut obove.

in an interface Group-Async0

iam not able to configure the group of lines 322-333 see output:

ACCG007(config)#interface Group-Async0

ACCG007(config-if)#grou

ACCG007(config-if)#group-range ?

<1-320> Start of range

tty Terminal controller

x/y Slot/Port for Modems

x/y/z Slot/Subslot/Port for Modems

ACCG007(config-if)#group-range

Thx

Ali

Hello,

IOS used? Configuration? Is there an NM-PRI installed ?

Hi,

The problem is solved by upgrading the IOS

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: