putting ip address on ap

Unanswered Question
Jun 6th, 2007

Hi all, when setting up my 1200 series ap, do I put the ip address both on the fast ethernet interface and the BVI interface, or do I put no ip on the fast ethernet and just put one on the BVI and use the bridge-group command ?

please help

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
fargier Wed, 06/06/2007 - 01:25


Only on the BVI to the management.

There is a implicit bridge group if you use the vlan 1.

If you would like to make VLANs, it's little different in the way of the non tagged you want.



This Discussion