sh int summary parameters

Unanswered Question
Jun 6th, 2007
User Badges:

does anybody can explain

what is that parameters of sh int summary command ?


SW4510-PJCAP#sh int SUMmary


*: interface is up

IHQ: pkts in input hold queue IQD: pkts dropped from input queue

OHQ: pkts in output hold queue OQD: pkts dropped from output queue

RXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)

TXBS: tx rate (bits/sec) TXPS: tx rate (pkts/sec)

TRTL: throttle count


tks !


Antonio

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Antonio Brandao Tue, 06/12/2007 - 06:57
User Badges:

Tks Didyap,


But the parameters that i referred is :


- what is it ? - IHQ: pkts in input hold queue

- what is it ? - IQD: pkts dropped from input queue

- what is it ? - OHQ: pkts in output hold queue

- what is it ? - OQD: pkts dropped from output queue

- what is it ? - RXBS: rx rate (bits/sec)

- what is it ? - RXPS: rx rate (pkts/sec)

- what is it ? - TXBS: tx rate (bits/sec)

- what is it ? - TXPS: tx rate (pkts/sec)

- what is it ? - TRTL: throttle count


Tks

Actions

This Discussion