06-06-2007 06:05 AM - edited 03-05-2019 04:31 PM
does anybody can explain
what is that parameters of sh int summary command ?
SW4510-PJCAP#sh int SUMmary
*: interface is up
IHQ: pkts in input hold queue IQD: pkts dropped from input queue
OHQ: pkts in output hold queue OQD: pkts dropped from output queue
RXBS: rx rate (bits/sec) RXPS: rx rate (pkts/sec)
TXBS: tx rate (bits/sec) TXPS: tx rate (pkts/sec)
TRTL: throttle count
tks !
Antonio
06-12-2007 06:22 AM
Sh int command are following:
sh int s0, sh int, show int
For more command reference click following links:
http://networking.ringofsaturn.com/Cisco/ciscocommandguide.php
06-12-2007 06:57 AM
Tks Didyap,
But the parameters that i referred is :
- what is it ? - IHQ: pkts in input hold queue
- what is it ? - IQD: pkts dropped from input queue
- what is it ? - OHQ: pkts in output hold queue
- what is it ? - OQD: pkts dropped from output queue
- what is it ? - RXBS: rx rate (bits/sec)
- what is it ? - RXPS: rx rate (pkts/sec)
- what is it ? - TXBS: tx rate (bits/sec)
- what is it ? - TXPS: tx rate (pkts/sec)
- what is it ? - TRTL: throttle count
Tks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: