password recovery

6tgreene · ‎06-07-2007

I have a 7200 series router I need to do a password recovery on. When I reboot it and hit ctrl-break I still don't get into romon mode. I am using windows hyperterminal. I also tried to pull the flash out but it still boots.

Amit Singh · ‎06-07-2007

Hello,

Please follow the link below for password recovery on the 7200 routers. You have to press " Break " within 60 seconds after the reboot.

http://www.cisco.com/en/US/products/hw/routers/ps341/products_password_recovery09186a00800942d3.shtml

Use the link below ofr standard break sequence proceducres:

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml

HTH,Please rate if it does.

-amit singh

chris.lepa · ‎06-07-2007

Hi,

Check out this page:

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a0080174a34.shtml

Hope it helps.

-Chris

6tgreene · ‎06-07-2007

thanks anyway I have both of those doc's they didn't help

ariela · ‎06-07-2007

Hi,

maybe that could help you:

http://www.heinzulm.com/password.php

Regards

Andrea

aungsan.moe · ‎12-12-2007

Hi, I faced the same problem of password recovery on 7204 VXR with NPE-1G. I am using windows 2000 hyperteminal. I followed the procedure in the doc that I found in cisco website. it did not work. I am thinking of using another PC to try it again. Can you pls help us if you already have a solution to it.

Aung San Moe

glen.grant · ‎12-12-2007

Get something other than hyperterm , certain versions had problems issueing a control break . Go get something like Tera Term and I bet it will work .