Block 59 checksum failed

Unanswered Question
Jun 7th, 2007

Cisco Catalyst 2498G

It was given to me to re-configure. Apparently it was in a wiring closet that got hit by lightning. seems to work ok after I did some work on it, but this error shows up in the logs

6/7/2007,06:24:52: check_block_and_log:Block 59 checksum failed: 0x55EE(0x55


anything I need to be worried about? Every port seems to test out fine and I can navigate in the Console just fine.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
htarra Fri, 06/15/2007 - 10:20

It is NVRAM log error message.( check_block_and_log:Block 0 checksum failed).

A determination is then made as to whether or not a checksum was required to ascertain the value of any digit within the POSTNET barcode, as shown in block 59.


This Discussion