Cisco SNMP Trap

Answered Question
Jun 7th, 2007
User Badges:

Dear folks,


Is there any document the suggests/recommends what traps should be enabled for fault management of Cisco devices?


I do not seem to be able to find the following MIB files:


CISCO-ITP-DSMR-SMPP

CISCO-ITP-DSMR-UCP

CISCO-ITP-DSMR


Any one know where I can find these files?


Thanks in advance,


T Dang

Correct Answer by jreekers about 10 years 3 weeks ago

Hi T Dang,


That's a very broad question as far as what traps should be enabled for fault management. I think a good place for you to start would be here:


http://www.cisco.com/en/US/tech/tk648/tk362/tk605/tsd_technology_support_sub-protocol_home.html


You'll see that much of this is dependent on the type of devices you're monitoring, the statistics you're interested in gathering, and other factors. Hopefully, that link is helpful.


As for the other part of your question regarding these MIB files:


CISCO-ITP-DSMR-SMPP

CISCO-ITP-DSMR-UCP

CISCO-ITP-DSMR


I've done some research into these, and it looks like these MIB files were removed as DSMR is no longer supported feature on ITP...so those MIBs are obsolete.


If you have a SGM, you still might be able to find them though. Either dowloaded from the from the sgm web page:

http://:1774/


there is a link at the bottom of the page.


Or The Zip file mibs.zip, located at the top of the SGM CD Image, contains these MIBs.


HTH,

-Joe

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
jreekers Thu, 06/07/2007 - 11:03
User Badges:
  • Cisco Employee,

Hi T Dang,


That's a very broad question as far as what traps should be enabled for fault management. I think a good place for you to start would be here:


http://www.cisco.com/en/US/tech/tk648/tk362/tk605/tsd_technology_support_sub-protocol_home.html


You'll see that much of this is dependent on the type of devices you're monitoring, the statistics you're interested in gathering, and other factors. Hopefully, that link is helpful.


As for the other part of your question regarding these MIB files:


CISCO-ITP-DSMR-SMPP

CISCO-ITP-DSMR-UCP

CISCO-ITP-DSMR


I've done some research into these, and it looks like these MIB files were removed as DSMR is no longer supported feature on ITP...so those MIBs are obsolete.


If you have a SGM, you still might be able to find them though. Either dowloaded from the from the sgm web page:

http://:1774/


there is a link at the bottom of the page.


Or The Zip file mibs.zip, located at the top of the SGM CD Image, contains these MIBs.


HTH,

-Joe

Actions

This Discussion