Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
353
Views
0
Helpful
1
Replies

Replace a 5509 with a 4703, which sup card is best in 4703

Go to solution
r.dell
Level 1
Level 1

‎06-07-2007 09:38 AM - edited ‎03-05-2019 04:34 PM

We are planning to upgrade a pair of 5509's for a pair of 4703 with 2 x 48 port gig Ether cards(yes smaller but the 5509 was over capacity module wise) What's the best SUP card to use in the 4703 ? There's nothing fancy on the 5509's they are just used for routing to the Backup servers, so theres a lot of l3 interfaces and lots of traffic at night.

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Amit Singh
Cisco Employee
Cisco Employee

‎06-07-2007 09:52 AM

I think you are talking about 4507r chassis. Do you need to run the ehanced routing protocol like EIGRP, OSPF or BGP. If yes, then you would need Sup4 or Sup5, other wise Sup2 + will be a good choice.

If you need 10GB connectivity you can look for L3 Sup5-10GE or Layer2 Sup2+-10GE. In my opinion Sup2+ should suffice your need unless you want to run enhanced routing protocol.

Please have a look at the Sup engines for 4500 Chassis.

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_data_sheet0900aecd801792b1.html

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_data_sheets_list.html

HTH,Please rate if it does.

-amit singh

View solution in original post

0 Helpful
1 Reply 1

Go to solution
Amit Singh
Cisco Employee
Cisco Employee

‎06-07-2007 09:52 AM

I think you are talking about 4507r chassis. Do you need to run the ehanced routing protocol like EIGRP, OSPF or BGP. If yes, then you would need Sup4 or Sup5, other wise Sup2 + will be a good choice.

If you need 10GB connectivity you can look for L3 Sup5-10GE or Layer2 Sup2+-10GE. In my opinion Sup2+ should suffice your need unless you want to run enhanced routing protocol.

Please have a look at the Sup engines for 4500 Chassis.

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_data_sheet0900aecd801792b1.html

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_data_sheets_list.html

HTH,Please rate if it does.

-amit singh

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card