Mapping a rogue CLIENT in WCS with 4404

Unanswered Question
Jun 7th, 2007

Hi.

Im running a 4404 (4.1.171.0) and WCS. I imported all the maps, placed the AP's etc.

Looks great! I can find rogue AP's no problem and place them on the map with the skull and crossbones.

However I cant figure out how to do rogue CLIENT mapping. Im almost positive It can be done but cant find it anywhere in the docs or forums.

Any help appreciated.

Bob

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
sadbulali Wed, 06/13/2007 - 11:07

Change the Search In to 'WCS Controllers'' under the Monitor->Security->Rogue Clients and search for rogue clients on the controller directly and then click on it and now you will see that Detecting APs are shown as well as the location if this rogue client was detected by location server.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode