06-08-2007 12:32 AM - edited 03-05-2019 04:34 PM
Hi,
I have 6500 with sup720 with 12.2 IOS running and i have Layer 2 port-channel (ISL trunk) between two CAT running HSRP for some of L3 VLAN.
When I reload any of CAT. After CAT comes up some of this vlan goes to "act/lshut" mode when i do show vlan so that HSRP status for that goes to INIT. I need to do manually "no shut vlan <Vlan number>"
Does any one faced this issue any time ? What is resolution for this so this issue doesn't happen again if i reload CAT.
Regards,
Chintan
06-08-2007 03:30 AM
Can you post your configurations
06-08-2007 05:47 AM
interface Vlan11
ip address 10.253.0.2 255.255.255.192
no ip redirects
standby 1 ip 10.253.0.1
standby 1 timers 1 3
standby 1 priority 101
standby 1 preempt
end
interface Port-channel1
description MLS_TRUNK
switchport
switchport trunk encapsulation isl
switchport mode trunk
logging event trunk-status
logging event bundle-status
Regards,
Chintan
06-08-2007 06:20 AM
Hi Chintan
Apologies if this is really obvious but after you do a "no shut vlan
Jon
06-08-2007 11:01 AM
Yes Jon I do it.
But my problem is why vlan go to active/lshut whne i reload which should not happen..right ?
chintan
09-12-2007 01:00 AM
Hi,
This was later found to be cisco defect and now it is resloved.
Thanks,
Chintan.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide