cable based failover config on asa 5520

Unanswered Question
Jun 8th, 2007


we had 1 5520 & have purchased 1 new asa 5520. we want to make cable based active/active failover on this 2 devices. can someone help me with sample config? i found some docs but that were for pix. i need on asa.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
acharyr123 Fri, 06/08/2007 - 04:27

could u please tell me my config is correct or wrong:

interface GigabitEthernet0/3

description STATE Failover Interface


failover link failover GigabitEthernet0/3

failover interface ip failover standby

acharyr123 Fri, 06/08/2007 - 04:48

can't active/standby filover be configured in asa in cable based failover mode?

cpembleton Fri, 06/08/2007 - 04:54

Your original post said Active/Active. Which one are you trying to do?


acharyr123 Fri, 06/08/2007 - 04:57

if i connect the 2nd asa in cable based failover mode, will the replication be done automatically? don't i need to specify the lan, wan side ip address also??


This Discussion