06-08-2007 04:14 AM - edited 03-11-2019 03:27 AM
hi,
we had 1 5520 & have purchased 1 new asa 5520. we want to make cable based active/active failover on this 2 devices. can someone help me with sample config? i found some docs but that were for pix. i need on asa.
06-08-2007 04:19 AM
Below is the 7.2 doc for failover.
Thanks,
Chad
06-08-2007 04:27 AM
could u please tell me my config is correct or wrong:
interface GigabitEthernet0/3
description STATE Failover Interface
failover
failover link failover GigabitEthernet0/3
failover interface ip failover 192.168.50.1 255.255.255.0 standby 192.168.50.2
06-08-2007 04:36 AM
You'll need to do that for each context that you have. You also need to configure the failover groups.
See this doc. Will show you everything you need for A/A failover.
Thanks,
Chad
06-08-2007 04:48 AM
can't active/standby filover be configured in asa in cable based failover mode?
06-08-2007 04:54 AM
Your original post said Active/Active. Which one are you trying to do?
Chad
06-08-2007 04:57 AM
if i connect the 2nd asa in cable based failover mode, will the replication be done automatically? don't i need to specify the lan, wan side ip address also??
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: