Jon Marshall Fri, 06/08/2007 - 14:46
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


If you are using layer vlan interfaces on your 4500 then just configure the port as a normal switchport and put it in the correct vlan. You should also be fine to turn on spanning-tree portfast provided you are not running the pix firewall in transparent mode.


If you are running 802.1q on the pix interface (ie logical interfaces) then you need to configure the port as a trunk.


HTH


Jon

Actions

This Discussion