06-08-2007 11:41 AM - edited 03-05-2019 04:35 PM
How should the port be configured for connection to a 515e PIX?
Solved! Go to Solution.
06-08-2007 11:50 AM
Hi
I should be configured as a access port in the particular vlan according to u r design.
Thanks
Mahmood
06-08-2007 11:50 AM
Hi
I should be configured as a access port in the particular vlan according to u r design.
Thanks
Mahmood
06-08-2007 11:53 AM
Could you please be more specific?
06-08-2007 11:55 AM
I need to configure the port for access to the data vlan.
06-08-2007 11:57 AM
switchport access vlan xxx
you also might want to enable portfast, and hardcode speed/duplex.
speed 100
duplex full
spanning-tree portfast
(dont forget to hardcode speed/duplex on the firewall)
06-08-2007 12:07 PM
thanks, not sure how to do that on the PIX though.
06-08-2007 12:18 PM
would not switchport mode access be good?
06-09-2007 12:42 AM
Hi
No,by giving this command u r making this port as a access port,but the vlan membership remains unkown.U need to define it in the vlan according to ur design.i.e the subnet which u r using for u r firewall.
By default the port will be in vlan 1.
Thanks
Mahmood
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: