Defining traffic flow

Unanswered Question
Jun 8th, 2007


I have a 7206 with 2x FE100 interfaces. I am looking for a way to define within the router IOS how to define which interface defined subnets pass traffic over.

For example I have FE1/0 connect to a LAN, I have connected to this segment. On FE2/0 I have another LAN, 192.168.2/0/24 connected to this segment. I need to be able route all traffic LAN and WAN traffic for segment one, only on FE1/0 and vise versa on segment 2. Can I do this with an ACL applied seperatly to each interface? Also, how can I define a default route ( 192.168.1.x) or ( 192.168.2.x). I have two sperate networks, all internet users, who will need to get out. Each of these interface are going to routed to different network routers.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mohammedmahmoud Sat, 06/09/2007 - 01:31


I guess that you need to do source based routing PBR (Policy Based Routing).

please review these documents and get back if you have further problems:

Policy-Based Routing

Configuring Policy-Based Routing

HTH, please do rate all helpful replies,

Mohammed Mahmoud.


This Discussion