06-09-2007 05:47 AM - edited 03-05-2019 04:36 PM
Is there any way to restart all SNMP processes on a Cat6000 switch?
I have tried "set snmp disable" then "set snmp enable" but it is not resolving my problem.
I am trying to pull SNMP info using a port map utility and it always hangs up on one, specific CatOS switch.
06-09-2007 06:10 AM
Please give me a "show snmp"
Thanks
Andrea
06-11-2007 08:28 AM
SNMP: Enabled
RMON: Disabled
Extended RMON Netflow Enabled : None.
Memory usage limit for new RMON entries: 85 percent
EngineId: 00:00:00:09:00:d0:97:f1:6c:00:00:00
Chassis Alias:
Traps Enabled: None
Port Traps Enabled: None
Community-Access Community-String
---------------- --------------------
read-only removed
read-write removed
read-write-all removed
Additional- Access-
Community-String Access-Type Number View
-------------------- -------------- ------- -----------------------------------
Trap-Rec-Address Trap-Rec-Community Trap-Rec-Port Trap-Rec-Owner Trap-Rec-Index
---------------- ------------------ ------------- -------------- --------------
06-11-2007 12:24 PM
Have you already tried "set snmp trap enable all"?
All traps are disabled by default and need to be added to the configuration, either individually or by with the all parameter.
Then check with 'test snmp'
HTH
Andrea
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: