Jon Marshall Sun, 06/10/2007 - 04:08
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Hi


You can use the Pix Device Manager (PDM) which is a web based GUI interface for configuring a pix.


Attached is a link to the PDM page where you can find an overview and Installation/Configuration links.


http://www.cisco.com/en/US/products/sw/netmgtsw/ps2032/index.html


HTH


Jon

JORGE RODRIGUEZ Sun, 06/10/2007 - 05:32
User Badges:
  • Green, 3000 points or more

You need to initially console to the PIX

to configure the inside interface and enable http in order to load the PMD(GUI interface).


For that this is what needs to be done to get you up and running with PDM


1-Console to PIX enable mode , config terminal


2- Configure the enable password


enable password password1


3-Enable http server services on PIX


http server enable


4-Configure IP address for the inside interface

Example:

ip address inside 192.168.10.1 255.255.255.0


5- Allow http access to the pix for any system on 192.168.10.0 subnet

Example:


http 192.168.10.0 255.255.255.0 inside


or allow any inside host as http 0.0.0.0 0.0.0.0 inside


6- Allow Telnet access to the pix , same as step 5 but replace http with telnet



Configure your PC TCPIP settings as :

IP: 192.168.10.20

MASK: 255.255.255.0

DG: 192.168.10.1 ( This is your inside PIX interface IP) or leave it blank if in same segment.



Connect your PIX and PC in a hub, if using a switch make sure you're in the same

segment as the pix.


Once both are connected make sure you can ping the pix 192.168.10.1 to ensure IP connectivity.


Then load your web browser and type:


https://192.168.10.1







here are couple of good links for starters:


Getting Started -Guide

http://cisco.com/en/US/docs/security/pix/pix63/configuration/guide/overvw.html#wp1045414



Configuring PDM

http://www.cisco.com/en/US/docs/security/pix/pix63/pdm30/installation/guide/pdm30CH4.html




leungcm Sun, 06/10/2007 - 06:20
User Badges:

Hi,


thanks for your put. I cannot donwload the PDM software because I haven't any account. Where do I get the demo / eval verison? the old version is welcome as well.


Best regards

leungcm Mon, 06/11/2007 - 06:42
User Badges:

Hi,


where do I get the software? thanks


Best regards


Actions

This Discussion