06-11-2007 02:17 AM - edited 03-03-2019 05:22 PM
Hi all,
Does anyone know how to implement VLAN's on a 2851 using the two Gig Ethernet ports whilst maintaining redundancy between both ports (ie BVI)?
I realise you can create subinterfaces on an individual port basis, however that won't provide redundancy across both built-in ports.
06-11-2007 02:21 AM
On the interfaces, put no ip address and a bridge-group. On the BVI, IP address. Globally, bridge irb and route ip. You can do that also at subinterface level. One interface will go "blocked" by STP.
Hope this helps, please rate post if it does!
06-11-2007 01:59 PM
Yes, however can you create subinterfaces on BVI's? My understanding was that you couldn't do this
06-11-2007 02:07 PM
No you will create the subinterfaces on the physical interfaces and defined the desired VLAN with "encapsulation dot1q
As a recognition to those providing answers, please rate useful posts using the scrollbox below!
06-11-2007 02:13 PM
Ok, thanks for your help. That sounds like the solution to me.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide