06-11-2007 09:08 AM - edited 03-13-2019 04:13 PM
Hi All ,
Just a quick one, i need to connect 32 Analog trunk lines to a PABX and 4 PRI's to the PSTN. any Suggestions on which Cards i could use on the ISR to achieve this
Thanks in Advance
06-11-2007 09:26 AM
Hi,
from the PBX point of view, trunk lines are FXO, that is, analog lines that normally go to the pstn. This means the voice gateway will need FXS ports.
If this is your requirement, be aware that the integration may suffer of problems, for example you will not be able to give DID to the PBX.
Anyway, considering the density, the minimum you can use is a 2821 with EVM-HD-8FXS/DID + 2 x EM-HDA-8FXS, 2 x VIC-4FXS, 2 x VWIC2-2T1E1, 1 x PVDM2-32.
Hope this helps, please rate post if it does!
06-11-2007 02:14 PM
Woops a small (but expensive) correction. You will actually need 2 x PVDM2-64 for the above, because even if is is an hairpinned configuration, IOS will not let create the voice port if there is not at least 1 DSP resource for each. 23 x 4 + 32 = 124.
This can turn out to be quite an expensive solution for an (apparently) simple task.
06-13-2007 06:36 AM
Hi Paolo,
Nice catch on this one! This really goes to show that you think these scenarios through (I always knew you did) 5 points for your continued great work :)
Thanks,
Rob
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide