Questions about interconnecting 2 6513's

Unanswered Question

Hi all,

My SW1 and SW2 are interconnected via ISL trunks (Port 2 of the SUP720 module). This works fine as I can ping a PC from SW1 to SW2 and a specific VLAN.

My questions is:

if for some reason the Trunks go down, how does the Stations on SW2 connect to the VLAN IP that was programmed on SW1? I cannot add the same VLAN IP Address on both switches as there's a conflict.

Ex: VLAN104 has an IP of 10.1.1.1 that was configure while connected to SW1.

I cannot do the same on SW2 as the IP is confliting.

How can this be resolved?

Would like to have theses 2 switches in an Active/Active mode, but how do they both share the same VLAN IP's?

Thanks for your help.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mahmoodmkl Tue, 06/12/2007 - 04:57

HI

Do u have any edge switches connected to these 6513's.Give u r the toplogy so that we can answer u further.

For gateway redundecny u can use HSRP.

Thanks

Mahmood

Actions

This Discussion