Loading Problems

Unanswered Question
Jun 12th, 2007

I have a new 1242 and I can never get to a config prompt. I have reset the ap and I still get the same issue. All I get is the following below.

*Mar 1 00:20:26.798: %LINK-3-UPDOWN: Interface BVI1, changed state to up

*Mar 1 00:20:27.799: %LINEPROTO-5-UPDOWN: Line protocol on Interface BVI1, changed state to up

*Mar 1 00:20:31.675: %LINK-3-UPDOWN: Interface BVI1, changed state to down

*Mar 1 00:20:32.674: %LINEPROTO-5-UPDOWN: Line protocol on Interface BVI1, changed state to down

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ebreniz Tue, 06/19/2007 - 03:40

BVI is the virtual interface. Try to upgrade the access point to a higher version, Reset it again and try again

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode