power inline interfaces

Answered Question
Jun 12th, 2007

hi

today i was looking at a 3750 switch and i found that support power inline command, but when i tried to apply this command in a n interface im taking a message that the specific interface (Gi 1/0/xx) does not support power inline...

Do i need any special module or i miss anything ?

thanks

I have this problem too.
0 votes
Correct Answer by Paolo Bevilacqua about 9 years 6 months ago

Hi,

Do "show ver". if you switch model has -PS- it supports poE, else it does not and cannot be upgraded to.

Hope this helps, please rate post if it does!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Paolo Bevilacqua Tue, 06/12/2007 - 11:51

Hi,

Do "show ver". if you switch model has -PS- it supports poE, else it does not and cannot be upgraded to.

Hope this helps, please rate post if it does!

Actions

This Discussion