cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
517
Views
0
Helpful
2
Replies

4506 High CPU

ckuriyar74
Level 1
Level 1

I have recently installed catalyst 4506 and configured as L2 switch.

But sometimes the CPU load reaches 99% and when i see the PM callback process takes more cpu load.

I hve attached the config file along with show process details.

Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.2(25)EWA9, RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by Cisco Systems, Inc.

Compiled Wed 21-Mar-07 11:35 by tinhuang

Image text-base: 0x10000000, data-base: 0x114B64F4

ROM: 12.2(31r)SG2

Dagobah Revision 226, Swamp Revision 34

4506-018 uptime is 3 days, 19 hours, 34 minutes

System returned to ROM by power-on

System restarted at 15:25:24 UTC Sat Jun 9 2007

System image file is "bootflash:cat4000-i9s-mz.122-25.EWA9.bin"

cisco WS-C4506 (MPC8245) processor (revision 10) with 262144K bytes of memory.

Processor board ID FOX111110JX

MPC8245 CPU at 266Mhz, Supervisor II+

Last reset from PowerUp

2 Virtual Ethernet interfaces

240 FastEthernet interfaces

2 Gigabit Ethernet interfaces

511K bytes of non-volatile configuration memory.

Configuration register is 0x2101

Any one can suggest solution for this?

2 Replies 2

ckuriyar74
Level 1
Level 1

I resolved the problem and now the CPU utilization is avg 30%

What was the problem?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: