06-12-2007 10:51 PM - edited 03-03-2019 05:24 PM
i have two routers attach for a tunnel. in both router i have configured a same area and i detected in bot router logs of:
%CLNS-3-BADPACKET: ISIS: L1 LSP, bad
max-area-addresses 0, ID 0100.6400.0034.00-00, seq 85, ht 0 from
0018.7425.6500 (GigabitEthernet0/0)
my problem is that my connectivity with my end system up and down (my ports and wires are correct)
my question is:
the problem is with my end system (ES) or problems with my hardware switch or cisco.
i havent ipv6 and my end system are devices lucent
06-15-2007 02:24 AM
Hi,
I am not quite sure, would you be nice to put your complete NSAP address as you have configured over the Lucent device.
May be you have either wrong NSAP format or it's length is not correct.
BR
Asghar
06-15-2007 02:27 AM
Would be nice if you also keep the configuration of the routers only CLNS part.
06-17-2007 12:41 PM
try configuring the following commands and let's see if your problem could be solved.
router isis
ignore-lsp-errors
08-26-2011 05:45 AM
Hello Erperts,
I've the similar problems... anything that you find to get resolve the issue.
BR//mehdi
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: