CME/SRST with Multicast MoH

Unanswered Question
Jun 13th, 2007
User Badges:

Hello All,


We just deployed a remote location running CME in SRST mode connected to a CallManager cluster. Everything works great with the exception of MoH. Multicast is not available on this particular WAN so we want to designate the CME/SRST router as a local multicast MoH source. The problem I see is that the multicast config is done under telephony-services (since this is running CME) and can not be set up under ccm-manager-fallback as it usually is. Is this configuration supported and if so, how can I confirm that i have it configured properly?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
thisisshanky Wed, 06/13/2007 - 06:31
User Badges:
  • Purple, 4500 points or more

I have been told, this config is not supported officially by TAC as it was not tested. I have tried this and it works just fine. Again the multicasting works only when phones are registered to CM. It will not work under fallback mode.


HTH


Sankar


PS: please remember to rate posts!

phunball00 Mon, 06/18/2007 - 07:11
User Badges:

Do you happen to have a sample config? I have it set up as I believe it should be, but stil no joy. I only get ToH...

MARK BAKER Thu, 09/20/2007 - 08:33
User Badges:
  • Bronze, 100 points or more

I have the same question about CME/SRST local multicast MoH.


Does it work when placing an IP phone to IP phone call on hold? I can get this to work, but have not been able to get MoH to work when a call comes in from the PSTN to the same CME/SRST gateway router.



Mark

Actions

This Discussion