06-13-2007 10:04 AM - edited 03-05-2019 04:41 PM
All, I am enabling this command on a port, but when I do a show storm-control <port> unicast, the output doesnt show any information.
I do have the NIC that connects to the server disabled right now, can this be why?
Solved! Go to Solution.
06-13-2007 11:27 AM
I don't understand, storm-control is disabled by default. Remove the commmand I suggested under the port config and it will be disabled.
06-13-2007 10:46 AM
sh run int f0/2
Building configuration...
Current configuration : 120 bytes
!
interface FastEthernet0/2
storm-control unicast level bps 25k
spanning-tree portfast
show storm-control fastEthernet 0/2 unicast
Interface Filter State Upper Lower Current
--------- ------------- ----------- ----------- ----------
Fa0/2 Link Down 25k bps 25k bps 0 bps
What type of switch are we dealing here ?
Can you post the port config ?
06-13-2007 11:01 AM
its a 3750. Here is the config. I can enter the command, but the command does not show in the config:
Current configuration : 171 bytes
!
interface GigabitEthernet4/0/15
description ServerA
switchport access vlan 201
switchport mode access
flowcontrol receive desired
spanning-tree portfast
end
06-13-2007 11:11 AM
Interesting, my ouput was from a 3750.
Remove the flowcontrol and copy and paste my storm-control command.
Post back with results.
06-13-2007 11:17 AM
Current configuration : 209 bytes
!
interface GigabitEthernet4/0/14
switchport access vlan 200
switchport mode access
flowcontrol receive desired
storm-control unicast level bps 25k
spanning-tree portfast
end
Interface Filter State Upper Lower Current
--------- ------------- ----------- ----------- ----------
Gi4/0/14 Forwarding 25k bps 25k bps 0 bps
06-13-2007 11:22 AM
It's showing up now, what was the syntax before ?
06-13-2007 11:25 AM
I am wanting it disabled on this port, not enabled.
06-13-2007 11:27 AM
I don't understand, storm-control is disabled by default. Remove the commmand I suggested under the port config and it will be disabled.
09-04-2011 10:11 AM
To the OP is this in relation to a Equalogic SAN document that tells us that we must disable this feature which is enabled by default? I searched Google and found this page.
Thank you,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: