06-13-2007 10:04 AM - edited 03-05-2019 04:41 PM
All, I am enabling this command on a port, but when I do a show storm-control <port> unicast, the output doesnt show any information.
I do have the NIC that connects to the server disabled right now, can this be why?
Solved! Go to Solution.
06-13-2007 11:27 AM
I don't understand, storm-control is disabled by default. Remove the commmand I suggested under the port config and it will be disabled.
06-13-2007 10:46 AM
sh run int f0/2
Building configuration...
Current configuration : 120 bytes
!
interface FastEthernet0/2
storm-control unicast level bps 25k
spanning-tree portfast
show storm-control fastEthernet 0/2 unicast
Interface Filter State Upper Lower Current
--------- ------------- ----------- ----------- ----------
Fa0/2 Link Down 25k bps 25k bps 0 bps
What type of switch are we dealing here ?
Can you post the port config ?
06-13-2007 11:01 AM
its a 3750. Here is the config. I can enter the command, but the command does not show in the config:
Current configuration : 171 bytes
!
interface GigabitEthernet4/0/15
description ServerA
switchport access vlan 201
switchport mode access
flowcontrol receive desired
spanning-tree portfast
end
06-13-2007 11:11 AM
Interesting, my ouput was from a 3750.
Remove the flowcontrol and copy and paste my storm-control command.
Post back with results.
06-13-2007 11:17 AM
Current configuration : 209 bytes
!
interface GigabitEthernet4/0/14
switchport access vlan 200
switchport mode access
flowcontrol receive desired
storm-control unicast level bps 25k
spanning-tree portfast
end
Interface Filter State Upper Lower Current
--------- ------------- ----------- ----------- ----------
Gi4/0/14 Forwarding 25k bps 25k bps 0 bps
06-13-2007 11:22 AM
It's showing up now, what was the syntax before ?
06-13-2007 11:25 AM
I am wanting it disabled on this port, not enabled.
06-13-2007 11:27 AM
I don't understand, storm-control is disabled by default. Remove the commmand I suggested under the port config and it will be disabled.
09-04-2011 10:11 AM
To the OP is this in relation to a Equalogic SAN document that tells us that we must disable this feature which is enabled by default? I searched Google and found this page.
Thank you,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide