06-13-2007 09:19 PM - edited 02-21-2020 01:34 AM
Hi, my internet is a IP-8 PPPoE session. Now I try to install PIX515E failover but don't know how to config. If I use fix IP there is no default gateway in PPPoE setting. Somebody can help me?
06-15-2007 09:16 AM
Hello Amigo.
one of the failover requirements is to have static ip's configured. PPPOE is a dynamic way to get ip's, therefore failover will not support this.
06-15-2007 08:04 PM
You will need ASA ver 7.2 in order to do PPPoE. Also if it is a dynamic PPPoE connection, you may need the "setroute" command to set default route. See example below for dynamic PPPoE:
interface Ethernet0/0
nameif outside
security-level 0
pppoe client vpdn group bellsouthDSL
ip address pppoe setroute
!
vpdn group bellsouthDSL request dialout pppoe
vpdn group bellsouthDSL localname cisco@bellsouth.net
vpdn group bellsouthDSL ppp authentication pap
vpdn username cisco@bellsouth.net password 7779311
06-17-2007 04:24 PM
Thanks you very much! Because upgrade to high version is the next project so I will ask vender to change pppoe to fixed IP. Thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: