cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
445
Views
5
Helpful
2
Replies

QoS on OC-48 SRP interface on 10720 router

is_networkteam
Level 1
Level 1

We have a DPT ring with 10 10720 routers on it. The ring is connected to an OC-48 SRP interface on each router.

Voice traffic enters and leaves the 10720 on a Fast Ethernet interface; incoming voice has DSCP46 marking on it, and a strict-priority queue is set up outbound on the Fast Ethernet interface.

Is it possible to apply some form of priority queueing on the SRP1/1 interface on the 10720? I have been trying to find something definite about this but so far I have failed.

1 Accepted Solution

Accepted Solutions

swaroop.potdar
Level 7
Level 7

Router# conf t

Router(config)# interface srp 2/0

Router(config-if)# srp priority-map transmit 5

Router(config-if)# end

Please check this configuration guide, this should help you do the priority or other tasks with the SRP interface.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120s/srpapsgs.htm

HTH-Cheers,

Swaroop

View solution in original post

2 Replies 2

swaroop.potdar
Level 7
Level 7

Router# conf t

Router(config)# interface srp 2/0

Router(config-if)# srp priority-map transmit 5

Router(config-if)# end

Please check this configuration guide, this should help you do the priority or other tasks with the SRP interface.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120s/srpapsgs.htm

HTH-Cheers,

Swaroop

Hi Swaroop

Many thanks for your very useful reply. I have been looking for this kind of information for a long time!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: