Gateway Utilization Reports Blank

Unanswered Question
Jun 14th, 2007

Can you run Gateway Utilization Reports on a MGCP IOS based gateway on a Cisco 3845? When I run them, the reports come back blank. I can run reports for phones and phone numbers and they have data. But no data on the gateways. Thanks!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
q-conklin Fri, 06/15/2007 - 13:16

Have you gone to CDR > System > Sys Parameters > Gateway Config... and entered the info there? I believe this is a pre-req

MikeTomasko Fri, 06/15/2007 - 13:22

I just added the area code in for the PRIs. I'll give it a day or two and check it again. We'll see if that works. Thanks!


This Discussion