06-14-2007 01:02 PM - edited 03-14-2019 10:05 PM
Can you run Gateway Utilization Reports on a MGCP IOS based gateway on a Cisco 3845? When I run them, the reports come back blank. I can run reports for phones and phone numbers and they have data. But no data on the gateways. Thanks!
06-15-2007 12:33 PM
Anyone have any input/advice? Thanks!
06-15-2007 01:16 PM
Have you gone to CDR > System > Sys Parameters > Gateway Config... and entered the info there? I believe this is a pre-req
06-15-2007 01:22 PM
I just added the area code in for the PRIs. I'll give it a day or two and check it again. We'll see if that works. Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide