06-14-2007 10:59 PM - edited 03-03-2019 05:27 PM
I can see the ALM and CD alarms in my E1 card, i have specified the card type, my card is working fine as i have check with 1245 physical loop also. what is the CD alarm refer to....
06-14-2007 11:04 PM
Do "show controllers E1" and you will see what the alarms are. Usually, no signal, that means, bad cabling, or faulty circuit.
Hope this helps, please rate post if it does!
06-15-2007 02:16 AM
The CD alarm is the CARRIER DETECT alarm. It means you are not seeing the remote end from a layer one prospective. Do you have a RED Alarm on the line? You probably have a line issue or cabling issue....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide