06-15-2007 01:39 PM - edited 02-21-2020 03:06 PM
I setup VPN using the wizard and I can connect but I can't get to internal resources. I'm not sure if I need to add a route somewhere but I'm sure this is an easy one but I don't usually focus on Security.
06-15-2007 01:49 PM
06-15-2007 07:37 PM
The biggest problem I see from a glance, you should put your VPNPool in another subnet besides the inside network (192.168.1.0/24).
Also, your interface WirelessGuestLAN should be lower security level besides 100 (which is the same as your inside interface)
example:
ip local pool VPNPool 10.1.1.1-10.1.1.31 mask 255.255.255.224
!
access-list Inside_nat0_outbound extended permit ip any 10.1.1.0 255.255.255.224
!
access-list HPMVPN_splitTunnelAcl extended permit ip any 10.1.1.0 255.255.255.224
!
no access-list HPMVPN_splitTunnelAcl standard permit any
06-17-2007 01:59 PM
Thanks for the response Khary, I'll let you know how it goes.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: