Integration between Cisco VOice gateway & Ericcsion MD110 EPBX

Unanswered Question
Jun 15th, 2007
User Badges:

Hi


Need to know what parameters needs to match in between Cisco VG & Ericcsion PBX while integration(india off is going to connect through MPLS link(E1) via VG to US, in US we have avaya PBX)


We have a E1 connection (trunk) between VG & PBX.

Also need physical connectivity details like cross or stratght cable details.

Send important doc link also


Regards

Naga.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Sat, 06/16/2007 - 03:47
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hello,


the pinout for the router is documented at at:

http://cisco.com/en/US/products/hw/modules/ps2641/products_module_installation_guide_chapter09186a008007cb4c.html


You will need to configure both PBXs for ISDN PRI as described at;

http://cisco.com/en/US/partner/products/ps6350/products_configuration_guide_chapter09186a00800ca716.html


Note the correct command is "isdn incoming-voice voice" and not "modem" as the documentetion wrong in this.


Hope this helps, please rate post if it does!

Actions

This Discussion