Integration between Cisco VOice gateway & Ericcsion MD110 EPBX

nagabhushanamj · ‎06-15-2007

Hi

Need to know what parameters needs to match in between Cisco VG & Ericcsion PBX while integration(india off is going to connect through MPLS link(E1) via VG to US, in US we have avaya PBX)

We have a E1 connection (trunk) between VG & PBX.

Also need physical connectivity details like cross or stratght cable details.

Send important doc link also

Regards

Naga.

paolo bevilacqua · ‎06-16-2007

Hello,

the pinout for the router is documented at at:

http://cisco.com/en/US/products/hw/modules/ps2641/products_module_installation_guide_chapter09186a008007cb4c.html

You will need to configure both PBXs for ISDN PRI as described at;

http://cisco.com/en/US/partner/products/ps6350/products_configuration_guide_chapter09186a00800ca716.html

Note the correct command is "isdn incoming-voice voice" and not "modem" as the documentetion wrong in this.

Hope this helps, please rate post if it does!